This filament has a woody smell when printing.
Excellent quality material, easy to print with a nozzle greater than 0.4mm.
Can be used on a cold table.
It is recommended, if possible, to print on a glass surface.
Filament Features:
- Smells like wood even after printing
- As it has a low percentage of PLA it is easy to print at low temperatures
- The final appearance of the print is made of wood, with approximately 80% wood fibers
Print Features:- Printing temperature: 205-235ºC
- Table temperature: 20º to 60ºC
- Melting temperature: 140ºC
- Softening temperature: +/- 45ºC
- You must use a nozzle: ≥ 0.4mm.
Spool dimensions:
- d1 Spool outer diameter Ø: 200mm
- d3 Spool inner diameter Ø: 52mm
- L1 Spool width: 45mm
- Empty spool Weight: less than 200g
Note: The spool may look different from the one shown in the image due to the spool return campaign.
There are two versions: 3D printed spool and plastic injection. Both have similar dimensions.
Manufacturer: Reprap.pt
